Obehaglig sajt
http://www.globalsecurity.org/index.html

CHARACTERISTICS OF CHAFF
The proposed action would employ RR-188 training chaff. When released from an aircraft, chaff
initially forms a sphere, then disperses in the air. The chaff effectively reflects radar signals in
various bands (depending on the length of the chaff fibers) and forms a very large image or
electronic “cloud” of reflected signals on a radar screen. The aircraft is obscured from radar
detection by the cloud, which allows the aircraft to safely maneuver or to leave an area. Since chaff
can obstruct radar, its use is coordinated with the Federal Aviation Administration (FAA). RR-188
training chaff has D and E band dipoles removed to avoid interference with FAA radar.
Chaff Composition
The RR-188 chaff used during training consists of extremely small strands (or dipoles) of an
aluminum-coated crystalline silica core. The chaff components (silica, aluminum, and stearic acid)
are generally prevalent in the environment. Silica (silicon dioxide) belongs to the most common
mineral group, silicate minerals. Silica is inert in the environment and does not present an
environmental concern with respect to soil chemistry. Aluminum is the third most abundant
element in the earth’s crust, forming some of the most common minerals, such as feldspars, micas,
and clays. Natural soil concentrations of aluminum ranging from 10,000 to 300,000 parts per
million have been documented (Lindsay 1979). These levels vary depending on numerous
environmental factors, including climate, parent rock materials from which the soils were formed,
vegetation, and soil moisture alkalinity/acidity. The solubility of aluminum is greater in acidic and
highly alkaline soils than in neutral pH conditions. Aluminum eventually oxidizes to Al2O3
(aluminum oxide) over time, depending on its size and form and the environmental conditions.
Stearic acid is an animal fat that degrades when exposed to light and air.
The chaff fibers have an anti-clumping agent (Neofat – 90 percent stearic acid and 10 percent
palmitic acid) to assist with rapid dispersal of the fibers during deployment (Air Force 1997). Chaff
is made as small and light as possible so that it will remain in the air long enough to confuse enemy
radar. The chaff fibers are approximately the thickness of a human hair (i.e., generally 25.4 microns
in diameter), and range in length from 0.3 to over 1 inch. The weight of chaff material in the RR-
188 cartridge is 95 grams (Air Force 1997).
A single bundle of chaff consists of the filaments in an 8-inch long rectangular tube or cartridge, a
plastic piston, a cushioned spacer and a 1-inch by 1-inch plastic end cap that falls to the ground
when chaff is dispensed. The spacer is a spongy material (felt) designed to absorb the force of
release. Figure 1 illustrates the components of a chaff cartridge. Table 1 lists the components of the
silica core and the aluminum coating. Table 2 presents the characteristics of RR-188 chaff.
Chaff Ejection
Chaff is ejected from aircraft pyrotechnically using a BBU-35/B impulse cartridge. Pyrotechnic
ejection uses hot gases generated by an explosive impulse charge. The gases push the small piston
down the chaff-filled tube. A small plastic end cap is ejected, followed by the chaff fibers. The
plastic tube remains within the aircraft. Debris from the ejection consists of two small, square
pieces of plastic 1/8-inch thick (i.e., the piston and the end cap) and the felt spacer. Table 3 lists the
characteristics of BBU-35/B impulse cartridges used to pyrotechnically eject chaff.


Policies and Regulations on Chaff Use
Current Air Force policy on use of chaff and flares was established by the Airspace Subgroup of
Headquarter (HQ) Air Force Flight Standards Agency (AFFSA) in 1993 (Memorandum from John
R. Williams, 28 June 1993). It requires units to obtain frequency clearance from the Air Force
Frequency Management Center and the FAA prior to using chaff to ensure that training with chaff
is conducted on a non-interference basis. This ensures electromagnetic compatibility between the
FAA, the Federal Communications Commission (FCC), and Department of Defense (DoD)
agencies. The Air Force does not place any restrictions on the use of chaff provided those
conditions are met (Air Force 1997).
A-5
AFI 13-201, U.S. Air Force Airspace Management, July 1994. This guidance establishes practices
to decrease disturbance from flight operations that might cause adverse public reaction. It
emphasizes the Air Force’s responsibility to ensure that the public is protected to the maximum
extent practicable from hazards and effects associated with flight operations.
AFI 11-214 Aircrew and Weapons Director and Terminal Attack Controller Procedures for
Air Operations, July 1994. This instruction delineates procedures for chaff and flare use. It
prohibits use unless in an approved area.
References
Air Force. 1997. Environmental Effects of Self-Protection Chaff and Flares. Prepared for Headquarters Air
Combat Command, Langley Air Force Base, Virginia.
_____. 1999. Description of the Proposed Action and Alternatives (DOPAA) for the Expansion of the Use of
Self-Protection Chaff and Flares at the Utah Test and Training Range, Hill Air Force Base, Utah.
Prepared for Headquarters Air Force Reserve Command Environmental Division, Robins
AFB, Georgia.
_____. 2000. Additional Information and Analysis of Proposed Use of Defensive Chaff in the
Airspace Known as the Carrabelle and Compass Lake Work Areas (Military Operations
Areas). Prepared for the U.S. Air Force Air Education and Training Command (AETC).
Tyndall Air Force Base, Florida.

----------
http://www.globalsecurity.org/militar ... order=r&cq=&id=46e3bcba53